Duerkopp Adler 175 Instruction Manual

175  176  179SpezialnähmaschineBetriebsanleitungInstruction manualPostfach 17 03 51, D-33703 Bielefeld • Potsdamer Straße 190, D-33719 Biele feldTel

3.4 Setting the working height–The working height can be adjusted between 750 and 900 mm(measured up to the top edge of the table top).–Loosen screws

4 Sewing drives4.1 Drive category, type and useThe following sewing drives are available:Subclass Clutch motor Clutch DCpositioning drive positioning

4.2 Mounting the control–Mount the control unit 1 with 4 screws under the table top 8.–Fasten the pow er supply cable of the c ontrol unit with the st

4.4 Mounting the pedal–Fasten pedal 5 on the stand strut 4.–Align pedal 5 as follows for ergonomical reasons:The center of the pedal has to be approxi

5 Mounting the machine head5.1 Fitting the machine headATTENTION!Remove the supporting screws at the front and in the center beforetilting the machine

GB2315.2 EarthingThe earthing wire on the sewing machine head bleeds off staticcharges of the machine head via the motor control unit to the mass.–Fas

6 Connecting the sewing drive6.1 Connecting the sewing drive to the mainsATTENTION !Work of every kind on the electric equipment of the special sewing

6.3 Connecting the control DA220C–Plug the cable of the reference value transmitter (pedal) intobushing B80 of the control.–Plug the cable of the moto

6.4 Setting the machine-specific parameters6.4.1 General notesThe functions of the sewing-drive control are determined by theprogram and the parameter

7 Pneumatic connectionATTENTION !The pneumatic units will only operate properly at a supplypressureof8to10bar.The sewing machine’s operating pressure

Alle Rechte vorbehalten.Eigentum de r Dürkopp Adler AG und urhebe rrechtlich geschützt. Jede, auch auszugsweiseWiederverwendung dieser Inhalte ist ohn

8 LubricationCaution: Risk of injury !Oil may cause skin eruption.Avoid a longer contact with the skin.Wash yourself thoroughly after a c ontact.ATTEN

9 Sewing testAfter finishing the assembly work a sewing test has to be made.–Plug in the mains plug.Caution: Risk of injury !Switch the main switch of

Table top cutout18

ForewordThis instruction manual is intended to help the user to become familiarwith the machine and take advantage of its application possibilities in

General safety instructionsThe non-observance of the following safety instructions can cause bodily injuries or damages to the machine.1. The machine

Index Page:Part 2: Installation instructions class 175  176  179 – Original Instructions1 Scope of delivery ...

21539647108

1 Scope of deliveryThe scope of delivery is dependent on your order.Prior to setting up, please check that all required parts are present.This descrip

3 Assembling the stand3.1 Assembling the stand components–Mount the individual parts of the stand as shown in the illustration.–Push the attached four

GB3.2 Completing the table top with the control and fastening it to the stand–Insertthemachineheadsupport15intotheboreofthetabletop.–Insert the rubber