Duerkopp Adler 579 Operations Instructions download pdf (Page 30)

19. Spreader

Caution Risk of Injury!

Set the spreader only in the “Safe Stop” position or with the machine

turned off.

Rule and Control

There must be a clearance between the forked spreader 1 and the left

looper 2 which corresponds to the thickness of the looper thread used

(see adjacent illustration X).

The right spreader 6 should move as closely as possible, but without

contact, at the upper side of the right looper 8.

The spreaders, which are under spring-pressure, are held in their end

position by the stops.

The fork of the left spreader should lie exactly over the thread hole of

the left looper (see adjacent illustration) and the point of the right

spreader centered over the tip of the right looper (see lower

illustration).

Correction

–

For the setting of the clearance to the loopers, adjust the spreaders

slightly.

–

For setting the end positions of the spreaders, loosen the screw 4

or 9 on the appropriate looper.

–

Turn the spreader stop 3 or 7 slightly.

–

Tighten screw 4 or 9.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 84 85

No comments

Duerkopp Adler 579 Operations Instructions Page 30